The key is the harmony between the blade shape and the hood.  This combination increases air flow and creates lift under the hood.  This lift allows the Hover Trimmer to move almost effortlessly through even thick brush.  The sharp blades make quick work of tough brush or groomed turn in no time.

Because the Hover Trimmer uses a blade, there is no string line to replace so this machine is not only faster and more efficient that string trimmer heads, it costs less in the long run and is far more environmentally safe.  So go fast, go safe, go clean and go green with Hover Trimmer.

The Hover Trimmer will attach to any brand of straight shaft string trimmer in a matter of minutes.  Simply remove the string head and take of the lower gear box (usually two screws), then slide on the Hover Trimmer hood and tighten, re-install the lower gear box and attaché the blades.  You are then good to go and use the speedy, efficient and safe Hover Trimmer to increase productivity.

The BowDry is a revolutionary ground drying machine that is designed to efficiently and effectively remove standing water from any surface. It is strong, light weight, quiet, easy to use and a “green” machine. The four wheel chassis evenly distributes weight to keep the turf in pristine condition while clearing the water.  In addition, the durable foam roller is also incredibly turf friendly while efficiently removing water.

The BowDry has a myriad of uses from real grass to artificial turf, tennis courts and baseball fields, pool sides and event areas, golf greens and running tracks. For any facility, school, golf course, sports complex or country club, the BowDry gets you back on dry ground fast and easy.  Don’t let sudden downpours or an afternoon thunderstorm ruin and event, game, match or tournament – BowDry will get you back to playable conditions in no time.

The BowDry arrives almost completely assembled. Simply attach the handle, adjust the squeegee bar and you are ready to go.

The Olympic is a 26” wide reel mower for an excellent cut on infields and specialty areas.  Its six blade real is easily adjusted between ¼” and 1 3/16” with a single handle.  The bed knife adjust to the reel for easy cleaning, back-lapping, sharpening, and maintenance.  The Olympic is powered by Honda’s GX-160 commercial grade engine.  Features include a padded and ergonomic handle, high grade steel chassis and catcher, gear and chain drive (no belts), and a split differential for fantastic maneuverability from a machine of this size.  Weighing in at 175 pounds, the Olympic delivers a superior cut, dynamic striping and great value.  This mower is an investment that will pay off for years to come.

Contact Seago for purchasing information, and be sure to see it at the STMA show in Daytona Beach, January 17-18.  Booth #925.

The GCV-160 engine, when used on a hover mower, is placed backwards so the spark plug faces the operator. This is done so that when the mower starts down a slope, the oil runs into the main sump area and keeps the crankshaft etc. lubricated. Honda uses a cup and dipper splashing system (an oil slinger) to keep the other parts of the engine coated. When the hover mower is at 45 degrees of slant or less, everything works as intended. However, when the mower is used at an angle steeper than 45 degrees, the oil in the main sump area can actually swamp the slinger causing a lack of lubrication around the top of the engine. By using a mixed fuel, the additional lubrication provided will usually protect the valves and other parts.

One very important note, choose a light mix and synthetic mix for best results. I have used Stihl Ultra at 50:1 and it works well.  I have also heard that Amzoil at 100:1 is a good mix too.   The synthetic mix burns clean and does not foul the plug. I want to stress that this has not been approved by Honda so they aren’t on board with this tip. But I have heard from techs from around the country that this has helped solve the problem of losing engines when using these machines on steep slopes.

The Wire Brush Wheel is specially designed to work with edging along asphalt, curbs or fence lines, in crevices or seems in concrete and brick or paver covered areas. Why the wire brush instead of blades or traditional sting? The answer is speed, consistency and ease of use.

Speed – The Atom Pro/CPE is the fastest walk-behind edger in the world to start with, and when using the Wire Brush Wheel on asphalt, you don’t lose any speed. The spinning brush pulls the edger along and all the operator needs to do is focus on keeping the machine straight. The power of the shaft drive Pro/CPE keeps the brush moving at a high rate of speed to quickly clip the grass and leave a good clean edge.

Consistency – The stiffness of the Wire Brush Wheel insures a clean and crisp edge even if the pathway is uneven. Since the wire brush wears evenly and very slowly, there are no rapid adjustment needed to compensate for broken line. In addition, the wire lasts so much longer than the nylon line it isn’t even fair to compare – you can get 25-40 MILES of edging done with a single brush.

Ease of Use – Because of the unique wheelbarrow design of the Atom edger, the weight of the machine is on the wheel so the operator isn’t carrying any weight. The forward rotation of the wire brush blade pulls the machine along and the operator gets the sensation of holding the machine back and therefor has outstanding control. The wheel is adjustable so the Atom can always be at a comfortable working level for the operator.

While the wire brush wheel may look odd, it is a great accessory that increases the versatility of the Atom Pro/Cart Path Edger. It is one of the only ways I know to quickly and easily edge or clean asphalt, pavers, brick, concrete joints etc. Give it a try – you won’t be disappointed.